Table of Contents
Advertisement
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately. Inspect before each use. Do not use if broken, bent, cracked or damaged parts
are noted. Any jack that appears damaged in any way, or operates abnormally shall be removed from service
immediately. If the jack has been or suspected to have been subjected to a shock load (a load dropped suddenly,
unexpectedly upon it), immediately discontinue use until jack has been checked by an Omega authorized service
center. It is recommended that an annual inspection be done by qualified personnel. Labels and Operator's Manuals
are available from manufacturer (see Replacement Parts, pages 5 thru 8).
PRODUCT DESCRIPTION
Omega Hydraulic Transmission Jacks are designed to be used as an aid in the removal and installation of
automotive and light truck transmissions, transfer cases and transaxles. Model Nos. 41100, 42000 and 43000 are
for use under portable lift equipment, where vehicle must be supported by appropriately rated jack stands.
SPECIFICATIONS
Model
41100
42000
43000
CAUTION: READ CAREFULLY BEFORE UNPACKING PRODUCT.
saddle
tilt adjustment
knobs
handle sleeve
position handle
pump handle
release valve
Figure 1 - Model No. 42000 (41100, 43000 similar)
Note: Oil Filler Plug is rubber and located centrally on
the upper portion of the reservoir. See exploded
drawing on pages 8, 9.
OIPM#41100-TJ2
Capacity
Base Size ( L x W )
1100 Lbs
31 1/8" x 15"
2000 Lbs
39 3/8" x 19 1/8"
46 3/4" x 25 5/8"
3000 Lbs
safety chains
lift arm
oil filler plug
(not shown)
swivel caster
Min. Height
8 1/2"
7 7/8"
7 7/8"
BEFORE USE
1. Inspect jack before each use. Do not use if bent,
broken or cracked components are noted. Ensure
that casters move freely. Check for and tighten any
loose assemblies.
2. Verify that the product and the application are
compatible, if in doubt call Omega Technical
Service (888)332-6419.
ASSEMBLY (41100, 42000, 43000)
Refer to figure 1:
Little or no assembly is required. Refer to the above
Figure 1 and the exploded view on page 6 thru 8 for
details in understanding the assembly and the
nomenclature of your product. Remove oil filler plug
prior to initial use to confirm oil level is at or just above
the inner cylinder as seen from the reservoir, fill as
needed and reinstall oil filler plug.
2
Max. Height
24 3/4"
33 1/2"
37 1/4"
Advertisement
Table of Contents
