Functions Menu A3 - Omega Engineering CN9400 User Manual

FUNCTIONS MENU
LEVL 4 LOCK
PROG NO.AL DIS.S DER.S
U S E R - P R O T E C T E D S E T T I N G S
LEVL 3 SP1.D SP2.D BURN REU.D REU.L SPAN ZERO CHEK READ TECH UER
C O N F I G U R E O U T P U T
LEVL 2 SP1.P
HAND PL.1
M A N U A L A D J U S T M E N T S
LEVL 1 TUNE
BAND INT.T DER.T DAC
PROGRAM ENTRY
Level C only visable
when COMMS
Option fitted
LEVL C ADDR
BAUD DATA DBUG
A3
C O M M S S E T T I N G S
Range of Adjustment shown in
description. If applicable, factory settings shown
in bold.
*
Note: Dual Relay and Dual SSd Output Options
Models CN9411 and CN9422 have their outputs
pre-configured. (see page 22)
S A F E T Y S E T T I N G S C A L I B R AT I O N
PL.2 SP2.A SP2.B DISP HI.SC LO.SC INPT UNIT
S P 2 M O D E S
CYC.T OFST SP.LK SPRR SPRN SOAK SET.2 BND.2 CYC.2
S P 1 S E T T I N G S
KEY
red under
RSET
P E R F O R M A N C E D ATA
QUICK START ENTRY
R A N G I N G C O N F I G U R E I N P U T
P R O G R A M M E R S E T T I N G S S P 2 S E T T I N G S
TO VIEW FUNCTIONS
Setpoint 1
Process temperature (PV) or Function (green)
Output
indicator
Setpoint temperature (SP) or Option (orange)
(green)
Setpoint 2 Output indicator (red)
INSTRUMENT ADJUSTMENTS
To enter or exit program mode: Press
To scroll through functions: Press or
To change levels or options: Press
To view setpoint: Press
To increase setpoint: Press
To decrease setpoint: Press
To reset an alarm or fault condition: Press
Notes: If in difficulty by becoming "lost" in program mode, press
together for 3 seconds to return to display mode, check the
INSTRUMENT ADJUSTMENTS above and try again.
When in program mode, after 60 seconds of key inactivity
the display will revert to either
or, if the initial configuration has been completed, the
measured value. Any settings already completed will be retained.
together for 3 seconds
together or together
together
together
together briefly
and
INPT
NONE