Transporting The Unit - Stihl FS 94 Instruction Manual

Depress throttle trigger lockout and
N
pull the throttle trigger – the choke
knob moves to the Run F position.
Warm up a cold engineat varying
speeds.
WARNING
Make sure the carburetor is correctly
adjusted. The cutting attachment must
not rotate when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
Depress the momentary contact
N
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Engine stalls in cold start position g.
Depress throttle trigger lockout and
N
pull the throttle trigger – the choke
knob moves to the Run F position.
Continue cranking in position F until
N
the engine runs.
STIHL FS 94 R
Running engine stalls in cold start
position g or under acceleration.
Continue cranking in position F until
N
the engine runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Engine is flooded
Move the choke lever to F and
N
continue cranking until the engine
runs.
Fuel tank run until completely dry
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
Set the choke knob according to
N
engine temperature.
Now start the engine.
N

Transporting the Unit

Using transport guard
The type of transport guard depends on
the metal cutting attachment supplied
with the machine. Transport guards are
available as special accessories.
230 mm Grass Cutting Blades
English
29