Operations; Basic Operations - Clarion RG-9451S Owner's Manual

3. OPERATIONS

Note:
• Refer to the diagrams in "2. CONTROLS"
(page 5) when reading this chapter.

Basic Operations

CAUTION
Be sure to lower the volume before
switching off the unit power or car's ignition
key. The unit remembers its last volume
setting.
Turning power on/off
1. Press the [PWR/SRC] button to turn on
power.
2. Press and hold the [PWR/SRC] button
(2 sec.) to turn off power.
Selecting modes
1. Press the [PWR/SRC] button to change
operation mode.
2. Each time the [PWR/SRC] button is pressed,
the operation mode changes as follows:
Radio AU1(AUX1)
Radio...
∗ If no operation is performed for 5 seconds or
more, the unit will return to the clock display.
Adjusting the volume
1. Press the [+] button to increase volume;
Press the [–] button to decrease volume.
∗ Volume range is 0 (minimum) to 31 (maximum).
Mute
Use this function to turn off the sound
immediately.
1. Press the [MUTE] button.
The sound turns off and "MUTE" appears in
the display.
2. Press the [MUTE] button again to cancel the
mute mode.
Switching the display
Press the [DISP/CLOCK] button to select
desired display.
6
RG-9451S
AU2(AUX2)
Setting the clock
1. Press and hold the [DISP/CLOCK] button.
The clock blinks in the display.
2. Press the [H] or [M] button to set hour or
minute.
3. Press the [ ] or [
∗ The clock is displayed in 12-hour format.
4. Press the [DISP/CLOCK] button to finish the
setting.
Setting the alarm
1. Press and hold the [ALARM] button. There
will be a short beep, the " " and the clock
blinks in the display.
2. Press the [H] or [M] button to set hour or
minute.
3. Press the [ ] or [
time.
4. Press the [ALARM] button to finish the
setting.
• Stop the alarm
There will be a beep for 3 minutes during
alarm, you can press the [ALARM] button
to stop the alarm.
• Turn on/off the alarm
Press the [ALARM] button to turn on or off
the alarm, and the " " is lit on or off.
] button to set the time.
] button to set the alarm