Starting The Engine - Cub Cadet Z-Force SZ Operator's Manual

b. The tension of the deck drive belts are maintained
by a spring mechanism that adjusts for wear and
stretch.
c. Examine the belts for cuts, fraying, and excessive
wear. Replace if any of these are detected.
d. Replace the deck cover.
11. Check if deck is level. When correctly adjusted the mower
deck should be level side to side, and the front of the deck
should be approximately 1⁄4" lower than the rear of deck.
If deck needs to be leveled, refer to the Maintenance &
Adjustments section.
12. Lubricate all pivot points listed in the Maintenance &
Adjustments section.
13. Adjust the seat for operator's maximum comfort, visibility
and for maintaining complete control of the tractor.

Starting the Engine

WARNING!
This tractor is equipped with a safety
interlock system designed for the protection of the
operator. Do not operate the tractor if any part of the
system is malfunctioning. Periodically check the
function of the interlock system for proper operation.
WARNING!
For personal safety, the operator must
be sitting in the tractor seat when starting the
engine.
NOTE: Refer to the Engine Operator's Manual for oil fill-up
instructions and refer to the Assembly & Set-Up section for
gasoline fill-up instructions.
1. Open the fuel shut-off valve by selecting the right or left tank.
2. Operator must be sitting in the tractor seat.
3. Engage the parking brake by pressing forward on the brake
pedal , then press down on the parking break/cruise control
lever and then release the brake pedal
Brake Pedal
Parking Brake/Cruise Control Lever
Figure 5-1
4.
5.
6.
7.
8.
9.
10.
Cold Weather Starting
When starting the engine at temperatures near or below freezing,
ensure the correct viscosity motor oil is used in the engine and the
battery is fully charged. Start the engine as follows:
1.
2.
. Refer to Figure 5-1.
3.
Make certain the PTO switch is in the disengaged (down)
position.
Move the throttle control to midway between its slow
fast positions.
Move the choke control into the CHOKE
NOTE: If the engine is warmed up, it may not be necessary to
place the choke control in the CHOKE
Turn the ignition key clockwise to the START
After the engine starts, release the key. It will return to the
NORMAL MOWING position.
CAUTION:
Do NOT hold the key in the START
position for longer than ten seconds at a time. Doing
so may cause damage to your engine's electric
starter.
As the engine warms up, gradually push the choke control
downward.
NOTE: Do NOT leave the choke control in the CHOKE
position while operating the tractor. Doing so will result in a
"rich" fuel mixture and cause the engine to run poorly.
Allow the engine to run for a few minutes at mid throttle
before putting the engine under load.
Observe the hour meter/indicator panel. If the battery
indicator light or oil pressure light come on, immediately
stop the engine. Have the tractor inspected by your Cub
Cadet dealer.
Be sure the battery is in good condition. A warm battery
has much more starting capacity than a cold battery.
Use fresh winter grade fuel. Winter grade gasoline has
higher volatility to improve starting. Do not use gasoline
left over from summer.
Follow the previous instruction for Starting the Engine.
and
position.
position.
position.
S 5 — o
ection peration
19