Setup For High And Low Frequency Monitor - Omega Engineering DP3300 Series User Manual

DP3300 Series User's Manual
FUNCTION
Division Factor
Limit 1
Limit 2
Limit 3
Relay deadband
Latching or non -
latching relay setup.
Limit outputs prog-
rammed as normally
open or closed
Time base for RATE
calculation (In seconds)

SETUP FOR HIGH AND LOW FREQUENCY MONITOR:

If the unit is setup as a frequency meter, then following SETUP steps are performed.
FUNCTION
Scaler
Division Factor
decrement
Limit 1
Limit 2
Limit 3
Relay deadband
DISPLAY SHOWS
active digit flashing.
'dIV FAC' followed by preset
division factor e.g. 12 with
active digit flashing.
'CH1 LT1' followed by preset Limit 1
value e.g. 123.4 with active digit
flashing.
For limits 2 &3 CH1 LT2, CH1 LT3
followed by limit value.
'dEAdbd' followed by deadband
value e.g. 0002
'LATCH' for latching mode.
'NON LCH' for non- latching mode.
LT1 N.O. or LT1 N.C
LT2 N.O. or LT2 N.C
LT3 N.O. or LT2 N.C
'T BASE' followed by previously
programmed value e.g. '1.999'
DISPLAY SHOWS
'SCALER' followed by preset scaler
value e.g. 10.00024 with active digit
flashing.
'DIV FAC' followed by preset division
by preset division factor. (e.g. 12`
with active digit flashing).
'CH1 LT1' followed by preset Limit 1
value e.g. 123.4 with active digit
flashing.
For limits 2 &3 CH1 LT2, CH1 LT3
followed by limit value.
'dEAdbd' followed by deadband
value e.g. 0002
Page19
TO CHANGE
active digit.
Push ^v key to increment or decrement
active digit. Push <NXT> key to
change active digit.
Push ^v key to increment or decrement
active digit. Push <NXT> key to
active digit.
NOTE: Limit3 is audio visual alarm only
--- it has no relay output.
Push ^v key to increment or decrement
active digit. Push <NXT> key to make
next digit active.
Push ^v key to obtain alternate mode.
Use ^V key to obtain
alternate mode.
Push ^v key to increment or decrement active
digit. Push <NXT> key to make next digit active
TO CHANGE
Push ^v key to increment or decrement
active digit. Push <NXT> key to
change active digit.
Push ^v key to inc rement or
active digit. Push <NXT> key to
change active digit.
Push ^v key to increment or decrement
active digit. Push <NXT> key to
active digit.
NOTE: Limit3 is audio visual alarm only
--- it has no relay output.
Push ^v key to increment or decrement
active digit. Push <NXT> key to make
next digit active.