Format Conversion Using The Rear Panel Switches - Panasonic AK-HC1800G Operating Instruction

Multi purpose camera
Hide thumbs Also See for AK-HC1800G:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Major operating controls and their functions
 Camera mounting hole (1/4-20UNC)
 Camera mounting hole (3/8-16UNC)
The screw holes can be used to secure the camera for installing it on camera housing,
and when using a pan/tilt head or a tripod. The screw holes are 10 mm deep.
Use screws which are less than 10 mm long.
 MENU switch [MENU]
A menu will appear on the monitor screen when MENU switch is pressed for at least
 seconds. The menu screen is cleared when the switch is pressed for at least  seconds
while the menu is displayed.
 ENTER/AWB switch [ENTER/AWB]
The item just below can be selected by pressing this switch while the menu is on the
screen.
When the menu is not displayed or the camera is in shooting mode, the automatic white
balance control (AWB) can be set with this switch.
 UP/ABB switch [UP/ABB]
The item just above can be selected by pressing this switch while the Main menu is
displayed.
While the Sub menu is displayed, any setting can be brought up to a higher value with
this switch.
When the menu is not displayed or the camera is in shooting mode, the automatic black
balance control (ABB) can be set with this switch.
 DOWN/BAR switch [DOWN/BAR]
The item just below can be selected by pressing this switch while the Main menu is on
the screen.
While the Sub menu is displayed, any setting can be brought down to a lower value with
this switch.
When the menu is not displayed, the color bar and the shooting conditions are
alternately indicated by pressing the switch for about 5 seconds.

Format conversion using the rear panel switches

When there is no menu display, the video output format is switched to
"1080/59.94i" or "1080/50i" if the MENU switch  or ENTER/AWB switch  is
pressed, respectively, while the UP/ABB switch  and DOWN/BAR switch  are
held down.
If switch  is then pressed, the video output format is switched in the following
sequence: 1080/0psf  1080/9.97psf  1080/5psf  1080/4psf 
1080/.98psf  1080/59.94i  1080/50i.
- 1 (E) -

Advertisement

Table of Contents
loading

Table of Contents