Front Cover - Daewoo FRS-2011 Service Manual

Refrigerator Leveling &
Refrigerator Leveling & Door Adjustment( If needed.)
Door Adjustment ( If needed. )
Refrigerator must be level in order to maintain optimal performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
In case freezer door is lower than refrigerator door
1 Insert a screw driver (flat tip) into a
groove of the left wheel (bottom of
freezer) and turn it clockwise until the
door is balanced. (clockwise to raise
freezer door ; counterclockwise to lower)
Unless the freezer door is balanced
by step 1, then follow the next steps.
In case refrigerator door is lower than freezer door
1 Insert a screw driver (flat tip) into a
groove of the right wheel (bottom of
refrigerator) and turn it clockwise until
the door is balanced. (clockwise to
raise refrigerator door ;
counterclockwise to lower)
Unless the refrigerator door is
balanced by step 1, then follow the
next steps.

Front Cover

After installation and/or door leveling, fasten front cover
with screws.(Remove the screws on the front bottom
panel first. Click and screw the cover)
Downloaded from Fridge-Manual.com Manuals
Open the doors, unscrew the front
2
cover and remove, if it is attached.
The front of refrigerator needs to be higher just a little than the back for easy
Caution
door closing, but if the wheel is raised too much for door balance, i.e. front of
refrigerator is too higher than the back, it can be difficult to open the door.
2 Loosen 3 hinge bolts(2 on the left + 1
on the right) a little. (Do not unfasten
them completely.)
Insert a hexagonal wrench into the
groove of adjusting nut and turn
clockwise until the door is level.
Loosen 3 hinge bolts(1 on the left + 2
3
on the right) a little. (Do not unfasten
them completely.) Insert a hexagonal
wrench into the groove of adjusting
nut and turn clockwise until the door
is level.
4 Once the door is balanced, fasten the
hinge bolts tightly and screw the front
cover.
3 Once the door is balanced, fasten
the hinge bolts tightly.
Attaching of W ater Filter Holder
Remove the back paper of the tape on the filter
holder and attach the filter holder on a suitable
place.
56
INSTALLATION GUIDE
...
Hinge Bolt
...