Husqvarna TS 73 R Operator's Manual page 32

12 Adjusting the traverse
Slide adjustment [see Fig. 10].
Adjusting the carriage on the rail [
Adjustment to be made only if rollers (D) become
misaligned with rails (R). Adjust both rails if necessary.
This adjustment is necessary only if the wheels (D)
no longer bear on the rail (R). (Contact points 1
• Loosen the four screws (L) without removing them.
and 2 on the wheels).
Separate switch/housing unit from base.
• Loosen the screws with a 13 wrench (not supplied).
Eliminate play between roller and rail by pivoting screws
• Loosen the 2 nuts
(C) with the 13 wrench.
using a size 13 spanner, then suppress the
• Retighten the two or four screws (A) and slide the cart
clearance between the roller and the rail by
all the way down the rail (R) to verify the setting. having the screws swivel clockwise
• If necessary, fine tune the setting by trial and error. size 6 male key (not supplied)
• Re-tighten the 2 nuts
In case of greater marking (when shocks occur) the rails
over the length of the rail
can be rotated by loosening the four nuts under the rail
adjustment.
assembly.
• Fine tune the adjustment if necessary.
13 Lateral table extension
• Position the extension to the left, or the right, to
ensure maximum stability when cutting large size
materials.
14 Important advice
• Tighten all the nuts and bolts regularly.
• When storing the machine, we recommend
removing the blade and storing it carefully.
• Check that there is sufficient water supply during
operation.
• Tighten the blade firmly.
• Make sure the contact faces of the flanges, blade
and axle are clean.
The manufacturer
responsibility for loss or damage
resulting
modification, alteration or powering
that does not conform to the
manufacturer's original specifications.
The noise level of this machine is
measured according to the S 31.069
standard.
At the work station, the sound
pressure level may exceed 85 db (A)
In this case individual protection
measures must be taken.
24
SEE FIG.
(A) opposite side of the disk
(C) using a
(A) and slide the carriage
(R) to check
declines
from misuse or
15 Repairs
S
A
x10].
V
16 Spare parts
For rapid delivery of spares and in order to avoid
any wasted time, it is necessary to remind your
supplier of the details shown on the instruction
plate on the machine with each order, as well as
the reference of the part to be replaced.
Item number
17 Scrapping
In the event of deterioration and
scrapping of the machine, the
following items must be disposed of
in accordance with the requirements
of the legislation in force.
• Main materials :
* Motor : Aluminium (AL), Steel (AC),
Motor :
* Machine : Steel sheet (AC)
all
any
The instructions for use and spare parts found in this
document are for information only and are not binding.
As part of our product quality improvement policy, we
reserve the right to make any and all technical
modifications without prior notice.
Contact your supplier who is entirely at
your service to carry out repairs in the
shortest time at the best possible price.
00000000 (0)
Quantity
See exploded view
Copper (CU), Polyamide (PA)