Table of Contents
Advertisement
10
en | Installation and Wiring
Always use all included support hardware when installing into suspended ceiling tiles to make
sure the installation is secure.
For sheetrock ceiling installations, the C-ring should be used by itself to reinforce the ceiling
material and to spread out the pressure from the speaker hold-down tabs. Guide the C-ring
through the cut hole in the ceiling, and place it on the back side of the hole before inserting
the speaker.
4.3
Step 3 — Attach Wiring to the Ceramic Connector
Insert the bare end of wire into the appropriate connector terminals as described below and
screw down the hold-down screw until tight, using a small screwdriver.
Figure 6:Tighten with screwdriver
When adding a subwoofer, be sure to observe the correct polarity. The LC2-PC60G6-10
subwoofer has been designed for optimum performance when used with the LC2-PC30G6-4.
In order to maximize the low frequency output when used with the LC2-PC30G6-8, LC2-
PC30G6-8L or LC2-PC60G-8H, the polarity of the LC2-PC60G6-10 subwoofer should be
reversed. See Figures 7 and 8.
Figure 7: Subwoofer polarity with LC2-PC30G6-4
2016.05 | 12 |
Installation and User Instructions
Prosound Ceiling Speakers
Bosch Security Systems B.V.
Advertisement
Table of Contents
