Table of Contents
Advertisement
FEATURES
GALVANIC ISOLATION
Using galvanic isolation the input signals are completely kept separated from each other.
This prevents problems with floating grounds and the two separate ground potentials for data and
audio.
Sound signals are switched with relays.
Data ground signal is switched with a relay.
Analog ground signal is switched with a relay.
Digital data signal flows via galvanic isolating optocouplers.
When power is not connected or in standby mode, sound output is muted with a mechanical relay.
LOSSLESS AUDIO PASS
The audio signals are passed without any modification; the output of the switch is the same that
enters the input.
DATALINK PASS
Datalink is passed to the output, from the selected input for display and other control.
DELAY AT POWER OFF
As the switching is controlled directly from the sources or an IR receiver, the speaker will power
off immediately, when no source is selected. When the speaker is powered off, sound signals will
be muted using a mechanical relay.
www.oneremote.dk
10
Advertisement
Table of Contents
