Lexus 2007 GS430 Quick Manual page 411

3-7. Other interior features
Programming a Rolling Code system (for U.S.A. owners)
n
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink " before proceeding with the
steps listed below.
Locate the training button on the ceiling mounted garage door
STEP 1
opener motor. The exact location and color of the button may
vary by brand of garage door opener.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
Press the training button.
STEP 2
Press and release the vehicle' s programmed HomeLink button
STEP 3
twice. The garage door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink transceiver and operate the garage door.
Repeat the steps above to program another rolling code system
STEP 4
for any of the remaining HomeLink buttons.
Programming an entry gate (for U.S.A. owners)/Programming all
n
devices in the Canadian market
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the sur-
STEP 1
face of the HomeLink .
Keep the indicator light on the HomeLink in view while programming.
Press and hold the selected HomeLink button.
STEP 2
Repeatedly press and release (cycle) the device' s remote control
STEP 3
button for two seconds each until step 4 is complete.
When the indicator light on the HomeLink compatible trans-
STEP 4
ceiver start to flashing rapidly, release the buttons.
336
I n f o r ma t i o n P r o v i d e d b y :