Sony SNC-RX550N Installation Manual page 52

7
To use the supplied cable cover, attach
the supplied cable cover mounting
bracket to the rear of the camera using
the supplied two screws (
Attach the bracket with the flat surface
downwards.
Ceiling
8
To extend the cables through the rear
of the cable cover, cut out the thinner
portion of the cover using a cutter
knife.
9
Temporarily attach the cable cover by
inserting the raised protrusions on the
cable cover into the gaps at the rear of
the upper ceiling cover. Then fix the
cable cover to the cable cover
mounting bracket using the supplied
M 3 × 8).
two screws ( 3
16
GB
Installing the Camera
M 3 × 8).
3
×
3
M 3 8
(supplied)
Cable cover
mounting
bracket
Removing the camera
1
2
3
4
Ceiling
Note
Take proper steps to ensure that the load
of the connected cables does not cause
problems.
Remove two screws used to attach the
cable cover in step 9 of
"Installation"and remove the cable
cover.
Disconnect the cables from the
connectors at the rear of the camera.
Remove three screws used to attach
the camera in step 5 of "Installation."
Pushing the entire camera up towards
the ceiling, turn the camera
counterclockwise as far as it goes,
then pull it out.
×
3
M 3 8
(supplied)