Troubleshooting; Protecting The Environment - Black & Decker SNC3650L252 Original Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

Troubleshooting

Problem
Solution
Snow thrower doesn't
Check to make sure safety key
run when bail handle
has been installed and is fully
is activated.
seated and that button on switch
housing is being completely
depressed before pulling bail
handle.
Release bail handle to turn snow
thrower off. Remove safety key
and battery pack, and check that
auger is free to turn.
Check that the battery cavity is
free of debris and is connected
properly.
Has battery been fully charged?
Unit stops while
Release bail handle to turn snow
moving snow.
thrower off. Remove safety key
and battery pack. Check that
auger is free to turn.
Check that the battery cavity is
free of debris and is connected
properly.
Has battery been fully charged?
Move charger and battery pack to
a surrounding air temperature of
above 40 degrees F (4,5°C) or
below 105 degrees F (+40,5°C).
Avoid overloading the Snow
thrower. Slow down working pace
(Original instructions)
Troubleshooting
Snow thrower is
abnormally noisy and
vibrates.
Battery charger LEDs
not on.

Protecting the environment

Z
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your BLACK+DECKER product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
z
Separate collection of used products and
packaging allows materials to be recycled and
used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
.
BLACK+DECKER provides a facility for the collection and
recycling of BLACK+DECKER products once they have
reached the end of their working life. To take advantage of this
service please return your product to any authorised repair
agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local BLACK+DECKER office at the
address indicated in this manual. Alternatively, a list of
authorised BLACK+DECKER repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com
ENGLISH
Release bail handle to turn Snow
thrower off. Remove safety key
and battery pack. Check that
auger is free to turn and ensure it
has not been bent or damaged. If
damaged, return Snow thrower to
a BLACK+DECKER Authorized
service centre.
If there is no visible damage and
the snow thrower still vibrates:
Return the snow thrower to an
authorized Black+Decker
authorized service centre.
Check plug connection.
Replace charger.
11

Advertisement

Table of Contents
loading

Table of Contents