Advertisement
Adjustin the Para-Bass Controls
The bass response in a system is affected by four factors:
(1) The acoustics of the vehicle
(2) The locations of the speakers
(3)The music on the tape
(4) Speakers and speaker enclosures.
Because of the variations in the recording process, we developed BASS-1 Oto help
restore any low frequencies lost during the recording process, however, the acoustics
of various environments are different.
The
control allows you to select a center frequency {the frequency most
Sweep
affected) between 27 and 63 Hz. The
of the filter centered around the
Settin The Bass Out ut Control
The BASS-10 is the most powerful bass component. This device equipped with several
different Bass Output selections. If you should need to change the settings, Please use
the chart below for guidance. It is recommended : listen to the factory setting before
changing your Bass Output settings.
Recommended Settings
s.& U in.9
2.5Volt
5Volt
7.5Volt
10Volt
SPECIFICATIONS
Maximum Input Level
Maximum Output Level-
Frequency Response
Total Harmonic Distortion
Signal to Noise Ratio
Balanced Input Noise Rejection __
Input Impedance
Output Impedance _ __
Power Supply
Power draw _
Recommend fuse rating -
control then allows you to control the shape
Width
frequency.
Sweep
Amg.!ifi.lr..1rul .u iJl2.!tag&
or less
3Volt
or
5Volt
less
7.
or less
5Volt
G
11111111111111111
Oh My
os
h
__
- - - · ·
10·
12·
15 Vrms
13.5V peak
10Hz-100KHz;+�1dB
0.003%
-130dB
>60dB
_ ____ _ _ 10 Kohm
_ 1500hms
High headroom PWM
150mA
1 Amp
Advertisement
