Advertisement
FUNCTIONS
THE OUTSIDE
1.
The inputs of The BASS-10 use a balanced input circuit to help minimize
Inputs:
induced noise. The are also designed to handle very high signal voltages up to 15
volts.
2.
Outputs:
These RCA connectors should be connected to the next component
after the BASS-10, such as a crossover, equalizer, or amplifier. Just remember, the
O
BASS-1
should go inline before a crossover.
3.
Dash Remote Control
4.
Power Connector
5.
Para-Bass Controls:
BASS-10. The SWEEP knob allows you to pick the centerfrequencythat you want
O
the BASS-1
bass restoration circuit to maximize. The WIDE knob adjusts how wide
of a frequency range the BASS-10 will effect.
6.
The PFM Subsonic Filter Switch:
Switch which will help with speaker control and amplifier power management. This
P FM Subsonic Fi
I
ter Switch comes with three frequencies selections 35Hz
80Hz. On most systems, setting the switch at 33Hz is fine. If you want to protect your
speaker system even more, you should try a higher frequency. Often a higher frequency
actuallly sounds louder and cleaner.
7.
Bass Maximizer Indicator:
maximization circuit is activated.
8.
LED.
Power On
BASS-I 0
DIGITAL BASS MACHINE
""""'°" "
IJIPUT
DUT"UT
DASH IMMOTt
These 2 knobs control the Para-Bass functions of the
The BASS-1
These three LED indicators flashes when the bass
0
•1�111 -. . N D
O
utilizers a PFM Subsonic Filter
I
50Hz
I
Advertisement
