Eizo ColorEdge CG222W Setup Manual page 8

Attach the left and right hoods to the monitor
Be sure to install the second hood only after the other hood is firmly attached with hook.
1
A ttach the top side of the left hood to the monitor first and
then securely fit the left side of the hood in order to fix the
hood to the monitor.
2
I nsert the hook into the upper hole on
the hood (1) and slide it down along
the projection on the back side of the
monitor (2).
3
Attach the right hood in the same way.
4
C heck the locations of the depressions
in the fitting and insert the fitting into
the left and right hoods by aligning
those depressions with the projections
( ) in the grooves on the right and left
hoods.
5
A ttach the open/close cover to the left hood.
Note
• Do not attach the open/close cover to the right hood. Doing so prevents
the cover from closing.
6
P lace the open/close cover on the top of the left hood (without
contacting the metal fitting) from front (1) to back (2).
7
S lide the open/close cover to the right (3) until it contacts the
stopper on the metal fitting.
8
W hen performing calibration, slide the open/close cover to the
left in order to attach the sensor.
Note
• The open/close cover does not slide onto the right cover.

Insert into the
upper hole