Table of Contents
Advertisement
32 Service Search
4.1.3 Configuring USALS settings
5. Finally set the Motor Control option to Store to save the
tuned position when the receiving quality is best.
There are more motor control options for installers, but this
guide does not describe them. If you are an installer, refer them
to the manual about the STAB rotor.
USALS (Universal Satellite Automatic Location System), also
known as DiSEqC 1.3, calculates the positions of all available
satellites from your location. Compared to DiSEqC 1.2, it is no
longer required to manually search and store every satellite
position. Just pointing to a known satellite position is enough.
This position will act as a central point. The USALS will then
calculate positions of visible satellites.
To get every satellite position calculated, perform the following
steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Enter your location to the My Longitude option and the
My Latitude option with the
tons.
To use the USALS protocol, se-
lect the Installation
USALS Setting menu.
Setting
You should see a screen like the
left figure.
At first you have to set the Mo-
torized DiSEqC 1.3 option to En-
able.
,
and numeric but-
V
V
Satellite
Advertisement
Table of Contents
