Smart Scan Method; Changing Factory Default Status - MAX DIGITAL XP1000 User Manual

6.1.2 Smart Scan Method

1. Power on TV using TV power button or TV remote control.
From this step all further remote controls should be done using the universal remote control and the remote control should be
directed towards the TV.
2. Press and hold the TV button more than 3 seconds. Then, two LED lamps from TV and STB buttons are flickering. Release the TV
button. Then, LED lamp from the TV button is flickering.
3. Press ▲ (up) or ▼ (down) button until TV turns off.
4. Once TV turns off, press OK button to store current setting. Then TV LED lamp will flicker 3 times and corresponding 4-digit code is
stored.
In case that the POWER (
procedure again to set different code.

6.1.3 Changing Factory Default Status

By default, remote control unit is supplied with volume-unlocked, channel-locked and master power reset status. However, you can
change lock status or set/reset status by following procedures.
6.1.3.1 Volume Key
Volume-unlocked status:
- In TV mode, volume related buttons (Volume +/-, Mute) are only working for TV.
- In STB mode, they are only working for STB.
Volume-locked status:
- Regardless of modes (TV or STB mode), volume related buttons (Volume +/-, Mute) are only working for TV.
How to set Volume-Locked status:
1. Press and hold the STB button more than 3 seconds.
2. If Vol+ button is pressed and then released, STB LED will be turned off and on.
3. Then, press Vol- button and release.
4. Press and release TV button to change the status. Then STB LED lamp will flicker 3 times.
How to set Volume-Unlocked status:
1. Press and hold the STB button more than 3 seconds to enter STB setting mode.
2. If Vol+ button is pressed and then released, STB LED will be turned off and on.
3. Then, press Vol- button and release.
4. Press and release STB button to change the status. Then STB LED lamp will flicker 3 times.
6.1.3.2 Channel Key
Channel-unlocked status:
- In TV mode, channel related buttons (CH+/-) are only working for TV.
- In STB mode, they are only working for STB.
Channel-locked status:
- Regardless of modes (TV or STB mode), channel related buttons (CH+/-) are only working for STB.
How to set Channel-Locked/Unlocked status (Locked/Unlocked status is toggled each other):
1. Press and hold the STB button more than 3 seconds to enter STB setting mode.
2. If CH+ button is pressed and then released, STB LED will be turned off and on.
3. Then, press CH- button and release.
4. Press and release OK button to change the status. Then STB LED lamp will flicker 3 times.
) button for TV is working but other important keys are not working, then follow the above
27