Bosch WAE20060UC Instruction Manual page 2

– Risk of scalding!
Allow detergent solution to cool down.
What to do if ...
Maintenance
– Turn off the faucet!
Suds discharge pump
Set cycle selector to Off, unplug the washer.
1. Open and remove service door.
2. Remove screws holding cover in place. Remove
begins transparent plastic cover.
3. Carefully unscrew pump cover until the washer suds
begins to run out. When the service door is half full,
screw back the pump cover and empty the service
door.
Repeat steps until all the detergent solution has run out.
4. Carefully unscrew the pump cover (residual water).
5. Clean the interior, pump cover thread and pump housing (fan impeller in
the detergent-solution pump must rotate).
6. Reinsert and screw on pump cover.
7. Place transparent plastic cover and secure with screws provided.
8. Insert and close service door.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 quart (approx. 1 liter) of water into dispenser II and select the Drain cycle.
Drainage hose at the siphon
Set cycle selector to Off, pull out the mains plug.
1. Loosen the hose clamp, carefully remove the drainage hose
(residual water).
2. Clean the drainage hose and siphon connecting piece.
3. Reattach the drainage hose and secure the connection with the hose
clamp.
Filter screens in the water supply hoses
Release water pressure in the supply hoses:
1. Close water faucet.
2. Select desired cycle (except for Spin/Drain).
3. Select Start. Let cycle run approx. 40 seconds.
4. Set cycle selector to Off. Unplug from main power supply!
Cleaning screen:
1. Remove hose from water faucet.
Rinse the strainers under flowing water.
Remove hoses on the rear,
take out screen with pliers and clean.
2. Replace hose and check for leaks.
8
7
Important Safety instructions
Water is running out. – Fasten drain hose correctly / replace.
– Tighten screw connection of the supply hose.
Water not entering – Start not selected? To reduce the risk of fire, electric shock, serious injury or death when using your washing machine,
washer.
– Water faucet not turned on?
Detergent not rinsed.
– Screen possibly clogged? Clean screen page 8. – BOSCH washers are provided with an Operating, Care and Installation Instructions Manual.
– Supply hose kinked or pinched? Read and understand all instructions before using the washing machine.
The loading door will not – Safety function active. Wait approx. 2 minutes.
– Do not wash articles that have been previously cleaned, washed, soaked, or spotted with gasoline,
open.
dry cleaning solvents, other flammable or explosive substances as they give off vapors that could
ignite or explode. This includes articles that have been exposed to Naptha.
Cycle does not start. – Start selected?
– Loading door closed? – Do not add gasoline, dry cleaning solvents, or other flammable or explosive substances to the wash.
Wash laundry in water only. Flammable or explosive substances may give off vapors that could
Programm is changed – Not a fault Start not selected immediately?
ignite or explode.
and water is drained. Water is drained to avoid water flowing out of open door.
Select Start to continue. – Under certain conditions hydrogen gas may be produced in a hot water system that has not been
used for 2 weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been
Sudsy water is not – Clean pump page 8.
used for this lenght of time, turn on all hot water faucets and let the water flow out of each faucet
pumped out. – Clean drain pipe and/or drain hose.
for several minutes before using the washing machine. This will release any accumulated hydrogen
Water cannot be seen in – No malfunction Water is below visible area. gas. As the gas is flammable, do not smoke or use an open flame while carrying out this procedure.
drum.
– Before the appliance is removed from service or discarded, remove the door and power cord/plug.
Spin results not – Wash small and large items together.
– Do not reach into the appliance if the wash drum is moving.
satisfactory.
– Do not install or store this appliance where it will be exposed to the weather.
Spinning several times. – No malfunction the automatic load balancing system is
attempting to balance the load. – Do not use bleach. Hazardous fumes can form.
Dispenser not – Remove dispenser. Clean detergent dispenser and liquid – Do not tamper with the controls.
completely rinsed out. detergent insert page 8.
– Do not repair or replace any part of the appliance or attempt any service unless specifically
Odor in washing – Perform Regular/Cotton Hot cycle without adding laundry. Also
recommended in the user maintenance instructions or in published user repair instructions that you
machine. use detergent.
understand and have the skills to carry out.
Foam comes out of the – Too much detergent added?
– Always unplug the washing machine from the power supply before attempting any service.
dispenser drawer. Mix 1 tablespoon fabric softener with 1 pt (½ liter) water and
Disconnect the power cord by grasping the plug, not the cord.
pour into dispenser II of the detergent drawer (not with outdoor
– To reduce the risk of fire, clothes, cleaning rags, mop heads and the like which have traces of any
fabrics!).
flammable substances, such as vegetable oil, cooking oil, petroleum based oils or distillates, waxes,
– Too much soap or non HE soap used?
fats, etc., must not be placed in the washing machine. These items may contain flammable
Mix 1 tablespoon fabric softener with 1 pt (½ liter) water and
substances which, even after washing, may smoke or catch fire.
pour into dispenser II of the detergent drawer (not with outdoor
fabrics!). – Do not machine wash fiberglass materials (such as curtains and window coverings that use
– Reduce amount of detergent used for future wash cycles. fiberglass materials). Small particles may remain in the washing machine and stick to fabrics in
subsequent wash loads causing skin irritation.
Strong odor, vibrations – Are machine feet fixed?
and "walking" during Secure machine feet Installation instructions page 5. – When children become old enough to operate the appliance, it is legal responsibility of the parents
spinning. or legal guardians to ensure that they are instructed in safe practices by qualified persons.
– Shipping lock removed?
Remove shipping lock Installation instructions page 3.
– Keep pets away from the washing machine.
Display lamps not – Power outage?
– Do not insert/pull out the power plug with wet hands.
functioning during
– Fuse blown? Flip/replace fuse.
operation. – If the malfunction happens repeatedly, call customer service. – Do not touch the door if washing at high temperatures.
Cycle runs longer than – No malfunction Imbalance control system equalizes imbalance – Use caution when draining hot water.
usual. by frequent distribution of the wash.
– Do not allow anyone to climb, lean or hang on any part of the washer including any protruding
– No malfunction Foam control system is active and additional
components such as the appliance door or a pull-out shelf.
rinse cycle has been started.
– Do not sit or stand on the top of the washing machine.
Detergent residues on – Some phosphate-free detergents contain water insoluble
– To reduce the risk of fire or electrical shock, DO NOT use an extension cord or an adapter to
the laundry. residues.
connect the washing machine to the power supply.
– Select Rinse or brush off the laundry after washing.
– The washing machine must only be used for its intended purpose.
If a malfunction cannot be repaired by yourself or if a repair is necessary:
– Set cycle selector to Off and unplug the washer's electrical cord.
– Always follow the fabric care instructions recommended by the clothing manufacturer.
– Close water faucet and call customer service Installation instructions.
9
Important Safety instructions
– Do not use the washing machine if it has a worn power cord or loose plug. Contact an authorized
WARNING
service agent.
– Make sure that all washer water connections have shut-off valves and are readily accessible. Close
follow basic precautions, including the following: the washing machine water shut-off valve(s) at the end of each wash day.
– Check the fill hose connections on a regular basis to ensure that they are tight and not leaking.
– Always read and follow the instructions of the manufacturer of the detergent(s), cleaning aid(s),
fabric softener(s) and static eliminator(s) which you are using. Heed all warnings and precautions.
– Store all laundry chemicals and aids in a cool dry place according to the manufacturers'
instructions.
– To reduce the risk of poisoning or chemical burns, keep all cleaning products out of the reach of
children.
– Do not operate the washing machine if any guards, panels and/or fasteners except transport fixing
bolts have been removed.
– Do not operate the washing machine if parts are missing or broken.
– Do not bypass any safety devices.
– To avoid floor damage and mold growth, do not let spills or splashes cause standing water around
or under the appliance.
– Do not operate this washing machine until you are sure that:
a. the washing machine has been installed according to the INSTALLATION INSTRUCTIONS.
b. all water, drain, power and grounding connections are in compliance with all local regulations
and/or other applicable regulations and requirements.
– Failure to install, maintain and/or operate the washing machine acoording to the manufacturer's
instructions may result in injury and/or damage.
– Removing any panel, including the service panel in the front can expose sharp edges and points,
electrical connections and hot surfaces.
– To avoid damage to the door, do not push against the door when moving the unit. Precautions
should be taken to avoid damage to the floor.
– The water connections should be made and tested before electrical power is applied to the
machine.
State of California Proposition 65 warnings:
This product contains chemicals known to the State of California to cause cancer, birth defects or
other reproductive harm.
Notes:
– The IMPORTANT SAFEGUARDS and WARNINGS indicated in this manual do not cover all possible
conditions which may occur. Common sense, caution and care must be exercised when installing,
maintaining or operating the washing machine.
– Always contact your dealer, distributor, service agent or the manufacturer about any problems
or conditions that you do not understand.
GROUNDING INSTRUCTIONS
– This appliance must be grounded. In the event of a malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance for the electric current. This
appliance is equipped with a cord that has an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
– Improper connection of the equipment grounding conductor can result in electric shock. Connect
to individual Branch Circuit. Check with a qualified technician or a licensed electrician if you are in
doubt as to whether the washer is properly grounded. DO NOT modify the plug provided with
appliance if it will not fit the outlet have a proper outlet installed by a qualified electrician.
– KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
In case of change of ownership, manual should be conveyed with the washer.
10 SAVE THESE INSTRUCTIONS.
Washing machine
en-us Instruction manual
11