Door Swing Option - GE TAX6 Use And Care Manual

TO CHANGE THE DOOR HINGES FROM THE RIGHT
SIDE OF THE REFRIGERIUTOR TO THE LEFT:
1. Unplug the retigerator and empty it.
2. Remove the countertop. See the Rehigerator
Installation section.
Top
3. Remove the top hinge and ifthere's a shim
under the hinge, remove it too. Set the hinge
(and shim) aside.
4. Open the door slightly and lift it off.
5. Carefully set the refrigerator on its back.
Leg
Spacer
6. Remove the levelhm leg below the bottom
hinge and the leveling~eg-ad leg spacer at the
opposite corner.
v
Shim
(on some models-
7. Remove the bottom hinge and ifthere's a
shim under the hinge, remove it too. Reinstall
the hinge (and shim) on the opposite side. Do
not tighten screws at this time.
8. Reinstall the leveling legs. Be sure the
leg spacer goes on the leg opposite the
relocated hinge.
9. Place the door on a flat nonscratching surface.
10. Remove the door stop and reinstall it on the
opposite side.
the plug button from the top edge
11. Remove
of the door and press it into the hinge hole on
the opposite side.
' \~,
.
-
12. Reinstall the top hinge (and shim, if any)
that you removed in step 3. Do not tighten
screws at this time.
13. Set the door on the cabinet, align it, and fit
the hinge pins into the door sockets. Then
tighten the top and bottom hinge screws and
stand the reliigerator upright.
14. If the rekigerator is to
reinstall the countertop. If the rehigerator is to
be recessed, remove the countertop retaining
clips and install the air grill before sliding the
refrigerator into place.
Bottom Hinge
0 1
0
\
L
*
be tiee standing,