Set Analogue channel manually [Analogue Manual Tuning]
Set Analogue channel manually after Automatic Channel Search.
Example: Antenna
Analogue Manual Tuning
Searching Channels
Start Frequency (MHz)
Scan up
[Scan up]: Scans ascendingly from the entered
frequency to higher frequencies
[Scan down]: Scans descendingly from the entered
frequency to lower frequencies
Check DVB-T signal condition [DVB-T Signal Condition]
Example:
DVB-T Signal Condition
Channel
10
Signal Level
Signal Condition
Bit Error Rate
Set DVB channel manually [DVB-T Manual Tuning]
Normally use [Automatic Channel Search] or [Scan] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
●
All channels found will be added to the Channel List.
DVB-T Manual Tuning
Scan
Channel
10
Signal Level
Signal Condition
List favourite DVB channels [Favourites Edit], Skip unwanted channels [Skip]
Create your favourite channel lists from various broadcasters.
1
Select a channel to list (
Favourites Edit
1
Analogue
2
Analogue
3
Digital
4
Digital
■
Skip unwanted channels
You can hide unwanted channels.
The hidden channels cannot be displayed except in this function. Use this function to skip unwanted channels.
Select a channel and reveal / hide
Skip
1
Analogue
2
Analogue
3
Digital
4
Digital
●
To change page (page up)
TH-L32_39EM5A_EN.indb 31
TH-L32_39EM5A_EN.indb 31
48.00
Scan down
9
96
These bars show the maximum signal value of the
91
9
selected channel.
0.00E-06
Change
Antenna
Access
0%
100
100
: Encrypted channel)
Select
Add / Remove
[Skip]
Select
Access
●
To change page (page down)
1
Enter the frequency to start scanning
2
Select the scanning method
Select
Access
: Add
: Remove
: Hide (skip)
: Reveal
●
To select
●
To exit
7/27/2012 5:28:42 PM
7/27/2012 5:28:42 PM
31