Advertisement
158878-01/doc
5/20/02
4:13 PM
Motor Brushes
Be sure tool is unplugged before inspecting brushes. Carbon
brushes should be regularly inspected for wear. To inspect brushes,
unscrew the plastic brush inspection caps (located in the sides of
the motor housing) and withdraw the spring and brush assemblies
from the tool. Keep brushes clean and sliding freely in their guides.
Carbon brushes have varying symbols stamped into them, and if
the brush is worn down to the line closest to the spring, it must be
replaced. New brush assemblies are available at D
service centers: see TOOLS, ELECTRIC in the Yellow Pages.
REVERSE
SIDE
HANDLE
SIDE HANDLE
EXTENSION
Page 3
Motor
Your D
your power supply agrees with the nameplate marking.
Volts 50/60 Hz or "AC only" means your tool must be operated on
alternating current and never with direct current.
Voltage decrease of more than 10% will cause loss of power and
overheating. D
WALT certified
operate, check power supply.
E
Switches
FIG. 1
Pulling the trigger switch turns the tool "ON"; releasing the trigger
switch turns the tool "OFF". For controlling the rotational direction
FORWARD
of the spindle, there is a lever, integral to and on top of the trigger
switch. For drilling (forward position) this lever should be slanted
LEVER
to the left side of the tool (viewing from behind the handle); for
TRIGGER
easing drill bits out of tight holes (reverse position) it should be
slanted to the right side of the tool. A built-in mechanical interlock
prevents changing the direction of the tool unless the trigger switch
is released. After any reversing, return lever to forward position.
Side Handles
TURN OFF AND UNPLUG DRILL.
NEVER ATTEMPT TO USE THIS TOOL WITHOUT A SIDE
HANDLE FIRMLY ATTACHED.
FIG. 2
The side handle must be attached to the gear case. Because of the
extremely high torque of this drill, a side handle extension must be
used to lengthen the side handle. The plastic bag that contains the
hex wrench and the chuck key also contains the handle extension.
Screw the extension firmly into the hole in the gear case of your drill
and screw the side handle into the extension. DO NOT USE
WITHOUT EXTENSION.
3
WALT tool is powered by a D
WALT built motor. Be sure
E
E
WALT tools are factory tested; if this tool does not
E
Advertisement
