Installation And Set Up Power Requirements; Connecting Power - Philips selecon plcyc1 MKII Installation & User Manual

Installation & User's Manual
INSTALLATION AND SET UP
1. Power Requirements
WARNING! The PLCYC1 MKII LED Luminaire should be connected to a constant circuit or a relay device. It
should never be connected to a dimmer or circuit controlled by a dimmer.
The PLCYC1 MKII LED Luminaire operates on 100 to 240 volts AC (+/- 10%, auto-ranging). The luminaire
contains an auto-ranging power supply. Depending on supply voltage, each luminaire can draw up to 140 Watts. The
maximum through current should not exceed 20 Amps*.
WARNING! *The Maximum Allowable Input Current of 20 Amps (and the maximum power supply limit of 140
Watts). Do not overload circuits! Must be supplied by a branch circuit protected by a maximum 20 Amp circuit
protector. Doit être alimenté par un circuit de dérivation protégé par un maximum de 20 ampères circuit
protecteur. Do not overload circuits!
IMPORTANT AC POWER CONNECTION NOTES:
a. Must be supplied by a branch circuit protected by a maximum 20 Amp
circuit protector. Doit être alimenté par un circuit de dérivation protégé
par un maximum de 20 ampères circuit protecteur.
b. When using the daisy-chain connection method, ONLY connect PLCYC1
MKII LED Luminaires to AC Output Connection of PLCYC1 MKII LED
Luminaires. DO NOT CONNECT OTHER TYPES OF LUMINAIRES
OR DEVICES!
c. Use only use approved cable types.
d. Do not overload circuits!
e. Do not connect PLCYC1 MKII LED Luminaires to dimmed circuits.
f. The MAXIMUM allowable number of PLCYC1 MKII LED Luminaires
which can be 'daisy-chained' on one power feed should not exceed
ratings. DO NOT EXCEED!

2. Connecting Power

Units can be powered in one of two ways:
• Direct connection to a AC power source using an AC input cable.
• Daisy chain connection using a interconnect AC cable.
6
INSTALLATION AND SET UP
AC Input Connection
PLCYC1 MKII LED Luminaire
AC Output Connection
(to next luminaire, optional)