Table of Contents
Advertisement
Installation & User's Manual
4. Mounting
PLCYC1 MKII LED Luminaires offer a plastic
monocoque yoke design for mounting by theatrical
clamps or hooks (sold separately).
For optimum performance and use, PLCYC1 MKII
LED Luminaires should be mounted and spaced as
shown in Figure 5.
How to read Figure 5:
• S = Spacing between fixtures
• D = Distance from fixture to projection surface.
• A ratio of S = D x 0.9 is the formula used to cal-
culate the optimum spacing for these fixtures.
WARNING! Before attempting any installation or
service, disconnect all power at power source.
Turning off the output of the luminaire does not
disconnect power. Installation and service should
only be performed by a trained and qualified
professional. Be sure to check circuit capacity
before installing luminaires.
5. Tilt Adjustments
To adjust luminaire tilt position:
Step 1. As shown in Figure 6, at tilt locking handle, loosen handle by twisting to the left.
Yoke Assembly
Tilt Locking
Handle
Luminaire
Head Assembly
Step 2. Position tilt (up or down) luminaire head assembly as desired.
Step 3. Hand-tighten, but do not over tighten, tilt locking handle.
8
INSTALLATION AND SET UP
gure 5: PLCYC1 MKII LED Luminaire Hanging / Spacing
6.7 in. /
170.5 mm
R 5.7 in. /
143.5 mm
R 7.7 in. /
195.0 mm
Figure 6: Tilt Adjustments
PLCYC1 MKII LED Luminaire
S
D
9.5 in. /
1.2 in. /
240.4 mm
30.2 mm
Hide quick links:
Advertisement
Table of Contents
