DeWalt DW0735 Manual page 13

Installing the tripod (fig. A, C & D)
• Release the plastic snap (7) at the end of the
nylon strap holding the tripod legs together.
• Spread the legs (3) apart to install the tripod in
upright position.
• Adjust the legs (3) if required so that each of the
feet (5) is firmly touching the ground.
• Take the shoes (8) off the feet (5) when using the
tripod outside. Step on each of the foot brackets
(4) to press the feet (5) into soft ground.
• Mount the tool to the tripod.
Adjusting the leg height (fig. A)
• Release the quick-adjust latch (2) of the first leg
(3) to set the desired height. Re-tighten the latch.
• Repeat as for the other legs.
Head mount
Elevating the head mount (fig. E)
The head mount (1) can be elevated in 2 stages up
to a maximum height of 2,80 m. The first stage is
operated by hand. The second stage is operated
using the swivel (9).
• Slacken the lock knob (10).
• Move the head mount to the required height or to
the maximum height of the first stage.
• Tighten the lock knob (10).
If further elevation is required, proceed as follows:
• Slacken the lock knob (11)
• Move the head mount to the required height.
• Tighten the lock knob (11).
Rotating the head mount (fig. E)
The head mount (1) can be rotated in order to allow
to rotate a laser, e.g. to transfer slopes.
• Slacken the lock knob (12)
• Rotate the head mount as required.
• Tighten the lock knob (12).
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your attachment has been designed to operate over
a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Re-adjusting the quick-adjust latch (fig. F)
• If the quick-adjust latch is loose in the locked
position, tighten the quick-adjust latch assembly
nut (13).
Unwanted products and the
environment
Take your attachment to an authorized D
repair agent where it will be disposed of in an
environmentally safe way.
E N G L I S H
WALT
E
13