Roland S-330 Owner's Manual page 8

How
to
handle the
S-330
>
•Switching
the
S-330
off will
erase
all
the data
programmed
in
the
S-330. Be
sure that
the
Power
switch
is
not touched
accidentally, or the
power
cord
is
not disconnected.
•The
appropriate
power
supply
for this
unit
is
shown
on
its
name
plate.
Please
make
sure that the
line
voltage
in
your country meets
the requirement.
•Do
not use the
same
socket used
for
any
noise generating device (such
as a
motor
or variable lighting system).
•This
unit
might
not
work
properly
if
turned on immediately
after
being turned
off.
If
this
happens, simply
turn
it off,
and
turn
it
on
again
after
waiting a
few
seconds.
•
When
turning the
S-330
on
or
off,
be sure
the disk drive
is
empty.
•When
disconnecting the cord
from
a jack,
do
not
pull
the cord but hold
the
plug.
•If
this unit
is
not
to
be used
for a
long period
of time, be sure
to
disconnect
the
power
cord from
the socket.
•
It is
normal
for
this
unit
to
get hot while being operated.
•Avoid
using
this unit
in
excessive heat or humidity, or where
it
may
be
affected
by
direct sunlight or
dust.
•Place
this unit
in
a steady, horizontal place.
If it is
inclined
upward
at
more
than
10 degrees or
downward
at
more
than 20
degrees, the disk drive
may
not
function properly.
•
Use
a soft cloth,
and
clean only with
a
mild
detergent.
•
Do
not use solvents such
as paint thinner.
•
When
moving
the
unit,
avoid sudden bumps
or shocks.
If
this unit
happens
to
fail
to
function properly, turn
it
off
once, then turn
it
on
again.