Advertisement
Installation:
For Wall Mounting
1. Hold the receiver unit against the wall to get an idea of where the receiver should be installed.
2. Install 1 nail (not included) on the wall.
3. Hang the receiver on the nail.
For Belt Clip
1. Using your finger, pull the tab on the top of the receiver to reveal the
belt clip.
2. Clip the receiver to a belt.
Pairing Accessories:
1. Enter programming mode by holding down the channel select button until the Channel 1 LED
flashes.
2. Press the channel select button to cycle through channels until the desired channel is selected.
3. Press the tone select button to cycle through ringtones until the desired ringtone is selected.
4. Trigger the accessory. Once the accessory is triggered, the receiver will beep indicating the
units have been paired. If another channel lights up, this accessory is already programmed on
the indicated channel.
Note: If pairing an accessory to a channel that is already paired with
another accessory, the original accessory will be deleted.
5. Press the channel select button to move to the next channel or exit
pairing mode.
Note: If no activity for 30 seconds the receiver will automatically exit
pairing mode.
Deleting Paired Accessories:
1. Enter programming mode by holding down the channel select button until the Channel 1 LED
flashes.
2. Press the channel select button to cycle through channels until the desired channel is selected.
3. Press and hold the channel select button and tone select button simultaneously until a beep is
heard. Press the channel select button to move to the next channel or exit pairing mode.
Note: The reset button is used to reset a channel after it has been triggered. It is not used to
clear any programming.
Setting the Notification Mode:
1. The Wireless Receiver has three modes—Alarm & Vibrate, Vibrate, and Alarm.
2. When the switch is flipped to Alarm, the receiver's built-in speaker will sound.
3. When the switch is flipped to Vibrate, the receiver will vibrate only and there will be no sound.
4. When the switch is flipped to Alarm & Vibrate, the receiver's built-in speaker will sound and vibrate.
SECO-LARM U.S.A., Inc.
Vibrate
Alarm & Vibrate
CBA Wireless Vibrating Receiver
Alarm
Belt clip tab
Channel
Tone
select
select
button
button
3
Advertisement
