Install/Remove Antenna; Wrist Strap And Belt Clip - Cobra MARINE HH500 Owner's Manual

Install/Remove Antenna

Installation VHF Marine Radio Protocols
Install/Remove Antenna
1. To install the antenna turn the antenna into the radio
Antenna
clockwise to tighten. Do not overtighten.
2. To remove the antenna turn the antenna counterclockwise.
This radio transmitter IC: 906A-MRHH500 has been
approved by Industry Canada to operate with the supplied
antenna. Other antennas are strictly prohibited for use with
this device.
Cet émetteur radio IC: 906A-MRHH350 a été approuvé par
Industrie Canada pour fonctionner avec l'antenne fournie.
D'autres antennes sont strictement interdits pour une
utilisation avec cet appareil.
Batteries and Charger
The radio is shipped with a sealed lithium-ion (LiON) battery
LiON Battery Pack
pack (P/N CM 110-026) that is rechargeable.
WARNING
The charger provided for this radio is only to be used
to charge the battery pack provided. Do not charge
any other type of batteries in the charger as fire,
explosion or battery damage will occur. Avoiding
extreme room temperatures will also help prolong
the life of the battery pack for the radio.
Install Battery Pack
When your rechargeable batteries begin to discharge too
quickly, it is time to install a new battery pack. Your radio
will also operate with five (5) high-quality AA alkaline
batteries, using the included alkaline battery tray.
Installing the Battery Pack
1. Position the battery pack over the back of the radio.
2. Engage the battery pack into the radio by sliding to the top
Tighten Screw
until battery pack is fully seated against radio housing.
3. Tighten the screw using the end of the belt clip to secure
the battery pack to the radio. Do not overtighten. Only use
the end of the belt clip to tighten the screw.
English
8
VHF Marine Radio Protocols Installation

Wrist Strap and Belt Clip

•
Belt Clip
Insert Belt Clip onto Radio
•
Wrist Strap Attachment
Secure Radio
Wrist Strap and Belt Clip
Belt Clip
Use the spring-loaded belt clip to carry the radio on your
person.
1. Slide the belt clip into the guide channel on the back of the
radio until it is locked in place.
2. To attach the wrist strap, insert it through the hole at the
top of the belt clip, feed it through the looped end and pull
tight to secure to the belt clip.
3. Press open the belt clip, slide it over the belt and release
the clip.
4. To remove the belt clip from the radio press the tab on the
belt clip, which unlocks the clip, and slide it out.
Nothing Comes Close to a Cobra
•
® 9