Table of Contents
Advertisement
MOUNTING OPTIONS
The Intellivox has two attachment points at the rear of
the enclosure; the device should be mounted using these
points. Each point consists of four M8 threaded inserts
20 mm deep, and only the hex-headed screws supplied
with the original mounting hardware should be used.
The Intellivox is equipped with a lifting
assistance attachment point (M10 threaded
insert) at the top of its enclosure. This should
only be used for lifting during installation and should NOT
be used as a permanent fixing point.
There are three options for mounting the Intellivox column:
1. The first (and most often used) method is to use the
standard mounting brackets supplied ready-fitted to
the unit. Dimensions of the bracket are shown in the
drawing below.
Fig.17 Mounting bracket dimensions.
18
JBL
Intellivox HP series Installation Manual Rev 1.2
®
The standard brackets allow mounting of the Intellivox
on a straight wall with a gap of 91 mm (3.6") between
the rear of the enclosure and the wall.
Details of mounting procedure are provided in
"Mounting Procedure"on page 19.
201601/IvxHPIM_v1.2
Advertisement
Table of Contents
