Save/Restore Panel - ATTO Technology 1100 Installation And Operation Manual

This panel saves the new configuration changes in FibreBridge NVRAM, restores values to the factory
defaults, or exits without saving the changes.
CAUTION New settings and newly flashed firmware will
not take affect until the FibreBridge power is cycled.
Leave This Session
Closes the current connection with the FibreBridge and
exits BridgeTools. Changed parameters during this session
will not take effect unless they were saved before closing the
connection.
Make Use of Saved Changes
Issues a restart firmware command to the FibreBridge. This
is the same as cycling power on the FibreBridge. Any
freshly saved configuration parameters or new firmware
will now be in effect.
Some options will be "grayed out" on the panel: they are not available because of the type of access mode or FibreBridge model or they have no effect based on other
Model/access method
Leave this session
Make use of saved changes
Save current settings
Set to factory defaults

4.10 Save/Restore panel

selections. The chart below shows options available based on model and access method.
2200/3200
Options in-band
G
G
G
G
Undo changes
Save Current Settings
Saves any changes made to the configuration parameters.
The FibreBridge will use these options the next time it is
powered up.
Set to Factory Defaults
Sets configuration settings to the factory defaults.
Undo Changes
Ignores any changes made since entering the BridgeTools
program and returns configurations to the last saved values.
2200/3200 2200/3200 4500
Ethernet serial port in-band
G G G
G G
G G G
G G G
G G G
4500 4500
Ethernet serial port
G G
G G
G G
G G
G G
22