Connecting To A D-Vhs With Hdmi Cables - Olevia 242T FHD User Manual

Connecting to a D-VHS with HDMI Cables

Disconnect all power sources before making any connections.
1.Connect a 75-ohm coaxial cable from your cable or antenna to the Set-Top-Box's Antenna jack.
2.Using Audio and S-Video (YPbPr, or HDMI is strongly recommended) cables, connect the Set-Top-Box's
Audio and S-Video OUT jacks to the TV's Audio and S-Video IN jacks.
3.Connect an I-Link cable from the Set-Top-Box to the D-VHS equipment for video transmission and record.
4.Using a HDMI cable, connect the D-VHS's HDMI OUT jack to the TV's HDMI IN jacks for watching the
recorded videos.
For 242 / 247 / 252 / 255 TFHD Models
Set-Top-Box
3
i-Link
cable
4
HDMI
cable
Note: HDCP is a copy protected digital connection that receives analog or digital video and audio signals from
equipment with a HDMI output that features the HDCP function. HDMI allows the transfer of digital
uncompressed data to the TV. This connection is superior when compared to the Component, S Video or AV
(composite) connections.
Note: HDMI signal is purely digital and provides a better picture, it is better than component, S-Video or Video
connections. It is strongly recommended to use this connection if you have this function on your equipment.
TV Installation and Connection Guide
Cable/Satellite
1
(75-ohm
coaxial cable)
Red
A/V cable with
RCA connector
White
2 Yellow
S Video cable
D-VHS
Rear of TV
22
Rear of TV