Nevir NVR-416T Instruction Manual page 9

RADIO
OPERATION
Set the FUNCTION switch (2) to the RADIO position.
Select the desired radio frequency band with the BAND SELECTOR (3).
The Dial Scale shows the frequency in MHz (for FM) or kHz (for AM).
Turn the TUNING KNOB (11) until desired radio station has been tuned in.
To turn off the radio, set the FUNCTION Switch (2) to the TAPE position.
ANTENNA
DO NOT CONNECT FM ANTENNA TO AN EXTERNAL ANTENNA
For FM reception, pull out the telescopic antenna (13). To improve reception,
incline and turn the antenna (13).
Reduce its length if the FM signal is too strong (very close to a transmitter).
For AM reception, the signals are picked up through the built-in ferrite antenna.
Rotate the radio itself to receive an optimum reception.
CASSETTE RECORDER
CONTROLS
STOP/EJECT button(6)
During operation, depress to stop all deck operation. Press again to open the
cassette door.
FAST FORWARD button(7) and REWIND button(8)
Press to rapidly advance the tape in either forward or reverse direction.
PLAY button(9)
Press to start playback.
PAUSE button(5)
Press to stop tape operation temporarily. Press again to resume tape operation.
RECORD button(10)
Press to start recording. PLAY button(9) will be activated automatically.
INSERTION AND REMOVAL OF CASSETTE TAPE
Press the STOP/EJECT button (6) to open the cassette door.
Insert a cassette into the holding position on the inside of the cassette door, with
the exposed section upward (playback side facing you).
Close the cassette door securely before starting.
When finished, press the STOP/EJECT button (6) to open the cassette door and
remove your cassette tape.
CASSETTE PLAYBACK
Set the FUNCTION switch (2) to the TAPE position.
Press the STOP/EJECT button (6).
Insert a pre-recorded tape into the cassette compartment.
Close the door gently.
Press the PLAY button (9) to activate playback.
Adjust the VOLUME control (1) to the desired sound level.
Press the STOP/EJECT button (6) when finished.
-Page 3