Sound Adjustment - Nevir NVR-416T Instruction Manual

POWER SUPPLY AND CONNECTION
BATTERY OPERATION
Set the FUNCTION switch (2) to the TAPE position.
Remove the battery compartment cover. (16)
Insert four D-size batteries.
Replace the battery compartment cover. (16)
Note:
Check your batteries regularly. Old or exhausted batteries should be
replaced.
If the unit is not going to be used for a long period of time or is being run
exclusively on an AC power supply, remove the batteries to avoid leaking and
damage to the unit.
AC OPERATION
Plug the Power Cord into an AC outlet. (127V/220V, 60Hz/50Hz)
Note:
This radio cannot be operated by batteries if the AC power cord is connected
to the unit.
CONNECTION
Stereo Headphone Jack (18)
Note:
Connecting Stereo Headphones (3.5mm) will mute the sound from the main
speaker.
FUNCTION
FUNCTION SWITCH
Position to RADIO for:
-Radio reception
-Cassette recording from the radio
Position to TAPE for:
-Cassette playback
-Recording from built-in Condenser Microphone (4)

SOUND ADJUSTMENT

VOLUME
The level of sound reproduced by the loudspeaker or Stereo Headphones is
adjusted by the VOLUME control (1).
Note:
During recording, adjusting the VOLUME control (1) only affects the monitor
sound and not the content of recording.
-Page 2