Download Print this page

Water Tank; Ultrasonic Disk - Germ Guardian H2000 Use & Care Instructions Manual

Ultrasonic humidifier
Hide thumbs Also See for H2000:

Advertisement

Always unplug the unit before servicing it in any way.
The water temperature of the water remaining in the unit after use may be high.
Do not submerse the unit in the water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash
out the unit with fresh water, using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft damp cloth if needed.

WATER TANk

If water spots remain in the water tank, wipe the inside down with a soft cloth.
Do not use soap or detergents.
AIR FILTER
Gently wipe away debris from the filter with a soft cloth.

ULTRASONIC DISk

Remove spray spout (Fig. 1) and use the enclosed cleaning brush to regularly
remove build up and deposits from this area (Fig. 2). White vinegar will help to
prevent this build up.
(Fig. 1)
(Fig. 2)
Fully dry the inside and outside of the unit before storing it.
DO NOT leave water in the unit.
Store in a cool, dry place.
E-6
PROBLEM
SOLUTION
Water vaopr & humidity are not
produced.
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Bucket Installation: Make sure the bucket is
correctly attached.
Air blows but water vapor is not
produced.
Excessive Water: Remove a certain amount of water
from the bucket.
The desired humidity is lower than the current
temperature: Increase the desired humidity.
Detergent residue in bucket: Wash the bucket
out and try again.
Humidity level is low.
The surface of the vibrator is dirty: Clean the vibrator.
The water in the unit is too cold: Replace with cool, but
not cold water.
Damage on the vibrator: Exchange the vibrator.
Warm humidity is not produced.
It may take 10-15 minutes before warm humidity
is created.
The humidity has a bad smell.
Poor maintenance or dirty water: Clean the product
thoroughly, and fill it with fresh water.
White dust is forming on nearby
furniture.
Hard water may deposit a certain amount of dust. Dust
in the air also settles because of added humidity in the
room. Use distilled water if this becomes a nuisance.
E-7

Advertisement

loading