Table of Contents
Advertisement
Mascot ST Tankless Water Heater
SECTION 5. Control Display and Operation
Index
A: Li or A: GA
b: Fr
C: Lc
d: OP
E: dH
F: Eh
h: In
L:rt
1: PH
2: rh
3: rH
L:rt
4: It
5: IH
J: AG
To change any of the above listed Status Parameters,
Press and Hold Button B
Rotate Dial E until you find the Parameter that you wish to change. Tap Dial E to enter that Parameter.
Adjust to the setting that you require and then press (tap) Dial E to save and to Exit.
Parameter
Flow 1
Fan rpm
Lock Mode
OP Temperature
DHW temperature
Exhaust Temperature
Inlet Temperature
Running Time
Power Supply Time
Burner Operating Time
Burner Operating Time
Ignition Attempts Number
Ignition Attempts Number
AGM Position
to get into the Status Display Mode.
5.4 Status Display Mode
Description
Current flow value(Li: L/m, GA: GPM)
Current fan rpm value
Lock mode is used(On) or unused(oFF)
Current Operating Temperature
Current DHW temperature
Current Exhaust temperature
Current Inlet Temperature
Display Running Time
Power Supply Time: 100 hour increments
Burner Operating Time: 1 hour incre-
ments
Burner Operating Time: 1,000 hour
increments
Ignition Attempts Number: 10 times unit
displayed
Ignition Attempts Number: 10,000 times
unit displayed
AGM Parameter calibration
Page 43
Advertisement
Table of Contents
