Philips DVP3355V/F7 Service Manual page 27

3 VCR Section
FLOW CHART NO.1
The key operation is not functioning.
Are the contact point and the installation state of
the key switches normal?
Is the control voltage normally inputted into
Pin(66,67) of IC501?
Replace IC501.
FLOW CHART NO.2
No VCR operation is possible from the remote control unit. (Operation is possible from the unit.)
Is approximately +5V voltage supplied to the Pin(3)
terminal of the RM2001 (remote control receiver)?
Is the "L" pulse sent out from Pin(1) terminal of
the RM2001 (remote control receiver) when the
remote control unit is activated?
Is the "L" pulse signal supplied to the Pin(5) of
IC501?
Replace IC501.
No
Yes
No
Yes
Terminal voltage of IC501-66,67
4.30
3.60
2.90
2.39
1.98
1.61
1.27
0.92
0.51
(V)
Yes
Yes
Yes
Re-install some key switches correctly or
replace some key switches.
Check the key switches and their periphery, and
service it if defective.
No
Check AL+5V(1) line and service it if defective.
No
Replace the RM2001 (remote control receiver)
or replace remote control unit.
No
Check the line between the RM2001 (remote
control receiver) and the Pin(5) of IC501, and
service it if defective.
1-10-7
KEY-1 KEY-2
IC501-67 IC501-66
-----
-----
----- -----
----- -----
-----
REC
-----
PLAY
STOP
S-INH
/EJECT
TRACKING
FF
DOWN
TRACKING
REW
UP
POWER OUTPUT
E8E6DTR