15. Appendix: Dual Control (Optional) INTRODUCTION The Enigma powerchair has been designed for a single occupant user mass of up to 135Kg. The design of the powerchair assumes that the user has limited mobility but has the physical, visual and cognitive ability to operate the powerchair safely.
There is a brake at each side of the wheel. These brakes should only be used when the powerchair is stationary and when in freewheel mode. Enigma Energi Owners Handbook Page 3 of 24 Part Code: Z20949 (Rev G)
It can also permanently damage the powered wheelchair’s control system. Enigma Energi Owners Handbook Page 4 of 24 Part Code: Z20949 (Rev G)
Page 5
Following the warnings listed below should reduce the chance of unintended brake release or movement as a result of EMI: Enigma Energi Owners Handbook Page 5 of 24 Part Code: Z20949 (Rev G)
Page 6
Powerchair). 5. Report all incidents of unintended movement or brake release to the Powerchair manufacturer and note whether there is an EMI source nearby PARTS DESCRIPTION Enigma Energi Owners Handbook Page 6 of 24 Part Code: Z20949 (Rev G)
Page 7
PARTS DESCRIPTION (CONTINUED) CONTROL FUNCTIONS OPERATION Battery Gauge On / Off Button Horn Speed / Profile Indicator Increase Speed / Profile Decrease Speed / Profile Enigma Energi Owners Handbook Page 7 of 24 Part Code: Z20949 (Rev G)
Page 8
Increase Speed / Profile. Press this button to increase the maximum speed of the wheelchair. Decrease Speed / Profile. Press this button to decrease the maximum speed of the wheelchair. Enigma Energi Owners Handbook Page 8 of 24 Part Code: Z20949 (Rev G)
Page 9
If you have a problem with your wheelchair consult the table overleaf. If the problem persists after you have followed the advice overleaf then restarted the wheelchair, contact Enigma Energi Owners Handbook Page 9 of 24 Part Code: Z20949 (Rev G)
Page 10
This is where the Speed Indicator and 10 bars are lit. A communication fault is indicated. Make sure that joystick 10 Bar + cable is securely connected and not damaged. Speed Enigma Energi Owners Handbook Page 10 of 24 Part Code: Z20949 (Rev G)
Page 11
Allen key. the canvas. Adjust these until you are comfortable, then secure the straps with Velcro. Enigma Energi Owners Handbook Page 11 of 24 Part Code: Z20949 (Rev G)
Page 12
(if half fold back mechanism is fitted). Make sure that the motors are placed in gear Make sure that there is sufficient power in the batteries Enigma Energi Owners Handbook Page 12 of 24 Part Code: Z20949 (Rev G)
Page 13
Enigma the powerchair in the event of an accident Energi may be used as a chair and may cause damage or injury in whilst the vehicle is moving with normal everyday use.
MOTOR 2 powerchair. Connect the powerchair up following the wiring diagram on the right. MOTOR 1 24V BATTERY SUPPLY JOYSTICK CONTROL VR2 POWER MODULE BATTERY CHARGER Enigma Energi Owners Handbook Page 14 of 24 Part Code: Z20949 (Rev G)
BATTERY CHARGING GUIDELINES 1. Do not disconnect the charger cord if charging is not complete. The battery life will be seriously shortened or decayed if the battery is Enigma Energi Owners Handbook Page 15 of 24 Part Code: Z20949 (Rev G)
Page 16
It is for this reason that the batteries must be correctly charged at all times else the peak point reached may not be the batteries’ optimum capacity and their lifespan may be dramatically reduced. Enigma Energi Owners Handbook Page 16 of 24 Part Code: Z20949 (Rev G)
Service Year 1 Year 2 Year 3 Year 4 Year 5 Dealer Sign / Date Customer Name Date of Purchase Address Colour Serial No. Options Included Postcode Enigma Energi Owners Handbook Page 18 of 24 Part Code: Z20949 (Rev G)
9. The frames on Enigma aluminium powerchairs have a five-year warranty. In the event of your powerchair requiring attention, please contact your service agent / dealer and give all relevant details so they can act quickly.
Check the batteries are charged up. Check all the connections are linked correctly. Please also refer to the section about the Controller Information Gauge on page 8 of this manual. Enigma Energi Owners Handbook Page 20 of 24 Part Code: Z20949 (Rev G)
KERB CLIMBER The Energi powerchair is available with an optional kerb climber which allows the powerchair to mount kerbs up to 4” (100mm) high. The bracketry to fit the kerb climber is now available as standard with all new Energi powerchairs.
Page 22
Remark: The manufacturer reserves the right to modify the specification if necessary. The final specification is subject to the individual powerchair you purchase from your dealer. Your Energi powerchair is a Enigma branded product. Enigma is a brand of Medicare Technology Ltd. Other products in the Medicare Technology range...
Page 23
DUAL CONTROL OPTION This user manual is an appendix to the Enigma Energi Owner’s Handbook. This user manual should be read in conjunction with the Enigma Energi Owner’s Handbook. This appendix covers the operation and simple maintenance of the dual control adaption for the Enigma Energi. The dual control adaption is...
Need help?
Do you have a question about the ENERGI and is the answer not in the manual?
Questions and answers