Front Panel - Nuvo NV-T2DF Installation Manual

Tuner A
Model NV-T2DF
Dual FM/AM/WX Tuner
FM 94.1
REMOTE
Classic Rock
STANDBY SENSOR
FM STEREO•AM•WEATHER
1 2 3 4

Front Panel

1. Stand-by LED: This LED (Light Emitting Diode) indicates that the T2 is plugged into an AC power source.
2. Remote Sensor: This IR (Infrared) receiver allows wireless remote control of the T2 functions. This IR input is active, even
when it is used in conjunction with the direct IR input on the back panel.
3. Frequency and Band Display: The display indicates the band AM, FM, or WX (Weatherband)and station frequency.
4. Preset/ RDS Display: This is a display of customized preset information, or RDS (Radio Data Service) information
transmitted with the station's broadcast. NuVoNet allows this to scroll automatically on the Concerto Display Pads (pg. 17 ).
5. Stereo: This indicates whether the signal reception is stereo. No display indicates mono. The T2 software allows a station
preset to be set in mono mode (pg. 21).
6. Signal Strength: This indicates the level of signal being received at the tuned frequency.
7. Select Knob: Turning the knob scrolls through the T2 menu options; pressing the knob selects the displayed menu option.
When not in menu mode, the Select knob tunes up and down. Pushing the knob selects the station.
8. Category Up and Down: This function requires the use of the T2 installation software. Categories allow station selection to
be set up according to specific listening genres.
9. Numeric Buttons: These buttons are programmable for direct station preset access. Customized alphanumeric strings can
be defined in the setup software (pg. 21). They can also be used for direct frequency tuning. These custom strings are
displayed on the Display Pads of an integrated Concerto system whenever a preset is accessed.
10. Display Button: This button toggles between RDS information on and off.
11. Memory Button: The memory button provides you with a personal "notepad" to store and recall artist and song information
originating from RDS data for future reference.
12. Menu: This button enters and exits the menu mode (pg. 11).
13. Pre/Dir: This toggles between numeric preset selection and direct station input.
14. Source: This button toggles between the available modes, AM, FM, WX (Weather Band), and Aux input if it has been
enabled through the advanced menu.
15. On/Off: Turns each individual tuner on and off.
10
11
SELECT
DISPLAY MEMORY
---
-–-
Stereo –-
–
- - - CATEGORY
– – –
1
PUSH TO
6
ENTER
5
6 7 8
12 13 14 15
Tuner B
MENU PRE/DIR SOURCE ON-OFF
AM 550
PRESET/DIRECT
3 5
2 4
FM STEREO•AM•WEATHER
7 8 9 0
9
Page 5
SELECT
DISPLAY MEMORY MENU PRE/DIR
---
-–-
–-
–
- - - CATEGORY PRESET/DIRECT
– – –
3
1 2
PUSH TO
6 7 8
ENTER
SOURCE ON-OFF
5
4
9 0