Advertisement
FAULT
1.- No programme works
2.- The appliance does not
load water
3.- The water does not drain
4.- The spin function does not
work
5.- Strong vibrations during
spin cycle
6.- The high-speed spin does
not work
Troubleshooting
CAUSE
• The appliance is not plugged
in.
• The general switch is discon-
nected.
• There is no electricity.
• The fuses in the electric insta-
llation are damaged.
• The door is open.
• See causes for 1.
• The tap is turned off.
• The filter is clogged.
• The outlet pipe is bent.
• The washing machine has not
yet drained the water.
• The "Spin Exclusion" option is
activated.
• The washing machine is not
correctly levelled.
• The anchoring device for trans-
port has not been removed.
• The wash load is not evenly
distributed.
• The wash load is not evenly
distributed within the drum.
If the problem or malfunctioning persists, disconnect the
machine, turn off the tap and do not try to repair.
For all repairs contact an Official Technical Assistance centre
(consult the European guarantee sheet) and always insist on the
use of original parts. Failure to do so may compromise the safety
of your machine.
When contacting a Technical Assistance Centre always refer to
the model (see also control panel) and the registration and serial
numbers indicated on the plate at the bottom front of the
machine behind the plinth panel or on the guarantee certificate.
That is to say, everything that appears in the box.
Providing this information will ensure a faster and more efficient
service.
SOLUTION
• Plug it in.
• Activate the general switch.
• Check.
• Check.
• Close the door.
• Check.
• Turn on the tap.
• Check the filter.
• Straighten the outlet pipe.
• Wait a few minutes for the was-
hing machine to drain.
• Enable the spin option.
• Adjust the feet.
• Remove the transport support.
• Distribute it evenly.
• Distribute the wash load evenly
in the drum.
12
Advertisement
