Control Panel - Electrolux EUP23901X User Manual

• Connect to potable water supply only.
Service
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

1
1 ON/OFF switch
2 Display
3 Function button
1 Door open alarm indicator
2 Positive or negative temperature indica-
tor
3 Temperature indicator
4 Action Freeze indicator
Switching on
After plugging the plug into the power out-
let, if the display is not illuminated, press
ON/OFF switch, appliance on.
As soon as the appliance is turned on, the
following signals will appear on the control
panel:
9) If a water connection is foreseen.
9) in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
2
4 Temperature regulator
Display
1 2 3
• Positive or negative temperature indicator
will be positive, indicating that the tem-
perature is positive
• the Temperature indicator flashes, the
background of the display is red and you
will hear a buzzer.
Press Function button and the buzzer will
go off (also see "Excessive temperature
alarm" ).
Place the Temperature regulator in a middle
position, and the appliance will be set up to
provide the following temperature:
roughly -18°C in the freezer.
are recyclable.
MODE
3 4
4
electrolux 15