Track Selection, Programming, Relay Play - Numark CDN 33 Manual

TRACK SELECTION
Track selection can be done 2 ways.
•
You can use the key pad by selecting the side, then the selection, then play
•
You can use the rotary selector on the individual player then press play
TRACK SEQUENCE PROGRAMMING
•
Select side to program
•
Press program, the unit will stop and the program indicator will light
•
Select the track to be programmed
•
Press the PROGRAM button
•
Select anther track to be programmed
•
Press the PROGRAM button
•
Press Play
You can program up to 30 tracks. Press PLAY to start the program. To exit and erase program hold the program button
down for more than 2 seconds while the unit is stopped, open the disc tray, or turn off the power.
RELAY PLAY
1. Insert CDs into both of the units.
2. Press the "RELAY" button.
3. Press play on the first unit. When that unit stops play it will send a signal to the second unit to start play. You will see the second
unit start play and the first unit pause. When unit 2 has completed play unit 1 will start.
Note: The play signal is sent at the end of specified play. If the unit is in SINGLE mode the play signal will start the second unit at the
end of the track. If the unit is in CONTINUOUS mode the play signal will be sent at the end of the full CD. Two CDs will play
continuously, alternating from unit to unit.
©2001 Numark Industries
- The Leader in DJ Technology
- 11 -
CDN 33
http://www.numark.com