NorthStar 10 kW Installation Manual page 32

If you want the radar to power ON automatically whenever the 6000i or 6100i is ON, use the
following power ON/OFF configuration:
where:
Key
A
B
C
E
F
G
H
I
J and K
If you want the radar to power ON automatically when the radar processor is powered ON,
omit the relay and leave Pin 10 and 12 on Connector 1 (the NMEA/Comms connector) as No
Connect.
3.10.3.8 Connect the 10 kW radar processor to an 8000i display
You are recommended to use the following configuration when connecting the radar processor to an
8000i display, where A is the (optional) NMEA Compass, B is the Circuit breaker/Fuse box, and C is the
vessel's Ground.
32
Component
Radar processor
Main PCB
NMEA/Comms port
Relay with (normally) closed contact
Fuse
NMEA port
Power port
Fuse /Breaker board
Battery
Northstar 10 kW Radar Installation Manual