Usage; Repair And Maintenance - Razor DIRT QUAD 500 Owner's Manual

USAGE

Starting the Dirt Quad 500
To start unit, while seated on seat, turn on power switch; place both
hands on handlebars and apply the throttle with right hand.

REPAIR AND MAINTENANCE

Turn power switch OFF before conducting any maintenance procedures.
• Read the instructions
• Remove charger plug
• Turn the power switch OFF
Replacing Battery
1
Carefully stand unit upright as
shown above.
4
Loosen wing nut located on
the top of the battery strap and
remove pin.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
• Secure the unit under repair
• Exercise caution around
exposed parts
2
Locate battery compartment and
squeeze metal tabs to gain access
to the batteries.
5
Depress the plastic tab on the battery connector to disconnect the bat-
teries. Using both hands, carefully remove batteries from unit.
Stopping the Dirt Quad 500
To stop unit, release the throttle and apply the brake until
the four wheeler comes to a complete stop.
• Contact Razor customer service
if unsure about any repair
or maintenance
3
Carefully lower battery tray.
6