Before You Begin - Razor DIRT QUAD 500 Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the cardboard separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred
during shipping. Because the Dirt Quad 500 is 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 5 for charging information).
Throttle
1.
Required Tools (Included)
6 mm Allen Wrench
Charger
(Note: Charger design may vary
from one shown)
Brake Lever
4.
3
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
DIRT QUAD 500. The Dirt Quad
500 has been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame and
all other parts. Certain aftermarket
products may not be compatible and
will void your warranty.
Product ID Locations:
1. Footstep (Right Side)
2. Charger
2.
3. Box (Not Shown)
4. Bottom of the Frame
(Underneath the Unit)
Plastic Bag Contents:
• Charger
• Allen Wrench
• Owner's Manual