Loading The Magazine; Operating Instructions - wurth DIGA CSM-1 Operating Instructions Manual

DIGA CSM-1.book Seite 14 Freitag, 15. August 2008 1:20 13
20
Close the cover 16.
When inserting the gas cartridge, small
quantities of combustible gas can escape. Do
not inhale the gas, do not smoke and keep
clear from open flames or sparks.
If gas is still detectable after inserting the gas
cartridge, remove the gas cartridge immedi-
ately and check the cause.

Loading the Magazine

– Insert the magazine strip as shown.
– Pull the tensioning slider 6 completely to the rear
and guide it back again until it faces against the
magazine strip.
– To remove the magazine strip, pull the tensioning
slider a little toward the rear. Actuate the release
lever 5 and guide the tensioning slider 6 back.
Actuate the retaining spring 21 and pull out the
magazine strip.
14
Structural Materials and
19 Fastening bolts may not be driven into unsui-
table materials or building components.
16
Recommended Structural Material
Check the thickness of the structural material. The
minimum required penetration depth of the faste-
ning bolts and the minimum strength of the structural
material must be given in order to reach secure fas-
tening of the attachment.
Structural
material
Concrete (DIN
1045, B10 - B55) 15–32 mm
Lime-sand brick
Steel
Solid brickwork
Minimum clearances and edge distances of
structural materials (according to § 18 BGV D9)
The distance from the shooting location to any free
edge must be large enough, to avoid sideward ex-
pulsion of the fastening bolt.
The fastening bolts must be driven-in with such clea-
rance to each other, that expulsion at the shooting
location due to breaking out or rupturing of the
material is avoided.
5
Distance to the
free edge
21
Clearance bet-
ween the faste-
ning bolts

Operating Instructions

Setting Bolts/Nails
1. Hold the tool firmly with both hands and ensure
secure footing.
2. Position the tool in a right angle to the surface of
the structural material. The neck-down sleeve 4
and the magazine base 10 must be seated secu-
rely.
3. Press the tool via the neck-down sleeve against
the surface of the structural material. This releases
the safety of the tool, the blower motor is switched
on and draws in air.
Clearances
Penetration Minimum
depths thickness
120 mm
ca. 40 mm 100 mm
ab 6 mm ab 6 mm
15–32 mm 100 mm
Brickwork Concrete, Steel
reinforce
concrete
3-times
the bolt
5 cm 5 cm shaft Ø
10-times 10-times 5-times
the bolt the bolt the bolt
shaft Ø shaft Ø shaft Ø