Options; Opening The Door; Programmes And Options, 8 - Indesit IDCA 735 Instruction Manual

Options

EN
The options allow for customising the selected programme according to one's own needs.
Delay start
The start of some programmes (see Programmes and options) may be delayed up to 9 hours. Press the button repeatedly to enter
the desired delay time. Before setting a delayed start, make sure that the water container is empty and that the filter is clean.
Post Anti-Crease
When this option is selected, the drum rotates garments at intervals after the cool drying cycle has ended, in order to avoid creases
forming on garments if they cannot be immediately removed at the end of the programme. During this phase, the indicator light is
turned on.
Pre Anti-Crease
When this option is selected in addition to the "Delay start" option, the drum rotates garments at intervals during the delay period to
avoid creases forming.
High Heat
When a drying time is selected, pressing this button sets high heat drying and the indicator light above the button lights up. The
timed programmes are pre-set to low heat.
! Not all options are available on all programmes (see Programmes and options).

Opening the door

If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following may
occur:
• The START/PAUSE button flashes orange.
• When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume the
"Delay start" programme. One of the "Delay start" indicator light flashes to signal the delay time entered.
• It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running pha-
se and the START/PAUSE indicator light stops flashing and turns green.
• During the post anti-crease phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from
the beginning.
• By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This
procedure can be used to select the Cool drying programme to cool garments if they are judged to be dry enough.
Press the START/PAUSE button to start the new programme.
Note: If you have a power cut, switch off the power or remove the plug. When power is restored, plug in the machine, press and
hold the ON/OFF button until the dryer reactivates, then press Start/Pause button.
10