Chrono Menu (Stopwatch) - Porsche cayman gt4 Owner's Manual

Partial monitoring
Monitoring of the other wheels is continued if there
is a fault in one or two wheel transmitters.
– The tire pressure warning light lights up.
– The message "Restricted monitoring"
appears on the multi-function display.
– No tire pressures are displayed on the
multi-function display for wheels with faulty
wheel transmitters.
No monitoring
In the event of faults, Tire Pressure Monitoring
System cannot monitor the tire pressure.
The warning light on the instrument panel lights up
and a corresponding message appears on the
multi-function display.
Monitoring is not active:
– If Tire Pressure Monitoring System is faulty.
– If wheel transmitters for Tire Pressure
Monitoring System are missing.
– During the learning phase after the tire settings
have been updated.
– After a wheel change without updating the tire
settings.
– If more than four wheel transmitters are
recognized.
– If there is external interference by other radio
sources, e.g. wireless headphones.
– If tire temperatures are too high.
f
Please see the chapter "OVERVIEW OF
WARNING AND INFORMATION MESSAGES"
on page 109.

Chrono Menu (Stopwatch)

You can use the stopwatch to measure any times,
e.g. on the race circuit or on work-related
journeys. Measured lap times can be stored and
evaluated if the vehicle is equipped with Porsche
Communication Management (PCM).
f
Please observe the chapter "SPORT DISPLAY"
in the separate PCM operating instructions.
Driving data can be displayed, recorded and
analysed on a smartphone using the Porsche
Track Precision app (country-dependent).
f
Please see the chapter "PORSCHE TRACK
PRECISION APP" on page 129.
Automatic lap counting and timing are possible
using the lap trigger available as an option via
Porsche Tequipment.
f
Please see the chapter "LAP TRIGGER"
on page 130.
Stopwatch on the dashboard
The stopwatch has an analoge and a digital
display.
The large pointer of the analog display measures
the seconds. The two small pointers measure
hours and minutes. The display re-starts at zero
after 12 hours.
Seconds and increments of
1/10th and 1/100th of a second can be read on
the digital display.
The digital display and the multi-function display
can show up to 99 hours and 59 minutes.
Stopwatch timing displays
The stopwatch time is displayed at different
positions on the dashboard:
– In the stopwatch on the dashboard.
– In the "Chrono" menu in the multi-function
display on the instrument panel.
– In the "CAR" main menu on the PCM.
Displaying the time on the stopwatch
You can configure the stopwatch on the
dashboard to display the time in the multi-function
display on the instrument panel.
For information on displaying the time on the
stopwatch:
f
Please see the chapter "DISPLAYING TIME IN
STOPWATCH ON DASHBOARD" on page 107.
Instrument Panel and Multi-Function Display
95