Porsche cayman gt4 Owner's Manual page 158

In front of the vehicle:
5. Hold the original remote control approx. 12 in.
(30 cm) away from the marked position
(illustration) and press and hold the transmit
button (for more than approx. 1 minute in
some cases) until the vehicle's turn signal
lights flash on and off three times or the
indicator light A on the overhead operating
console starts flashing quickly.
The turn signal lights flash three times and the
indicator light A flashes quickly to confirm that
the new signal has been programed
successfully.
Several attempts with different distances
between the vehicle and the original remote
control may be necessary.
With some systems, the transmit button on the
original remote control may need to be
pressed again when the indicator light on the
original remote control goes out.
156
Parking
6. The turn signal lights will flash once when the
5 minute teaching readiness period has
elapsed.
Repeat steps 3 to 5.
7. Repeat steps 3 to 5 to assign further signals
to the remaining buttons.
Assigning garage door opener signal to
button with changeable code system
With some systems, a changeable code also
needs to be programed for the HomeLink
system. A second person makes programing
easier.
Identifying the changeable code
f
Press and hold the previously programed
®
HomeLink button.
If the indicator light A on button II in the overhead
operating console starts to flash quickly and lights
up continuously after approx. 2 seconds, it means
that the equipment has a changeable code
system.
f
Information on synchronization can also be
found in the operating instructions for the
system to be programed.
Assigning garage door opener signal to key
f
Park the vehicle within the range of the remote-
controlled equipment.
On the overhead operating console:
1. Switch on ignition.
2. The standard factory-set codes must be
deleted before programing for the first time.
For information on deleting the factory-set codes:
f
Please see the chapter "PROGRAMING
GARAGE DOOR OPENER: DELETING AND
STORING SIGNALS" on page 155.
3. Press and hold the desired button on the
overhead operating console keypad until the
indicator light A on button II starts to flash
slowly.
You now have 5 minutes to teach the button.
4. Stand in front of the vehicle with the original
®
remote control of the system to be
programed.
In front of the vehicle:
5. Hold the original remote control approx. 12 in.
(30 cm) away from the marked position
(illustration) and press and hold the transmit
button (for more than approx. 1 minute in
some cases) until the vehicle's turn signal
lights flash on and off three times or the
indicator light A on the overhead operating
console starts flashing quickly.
The turn signal lights flash three times and the
indicator light A flashes quickly to confirm that
the new signal has been programed
successfully.
Several attempts with different distances
between the vehicle and the original remote
control may be necessary.
With some systems, the transmit button on the
original remote control may need to be
pressed again when the indicator light on the
original remote control goes out.