Philips qc5090 User Manual page 10

English
10
The appliance and the adapter may only be cleaned with the brush
supplied.
1 Make sure the appliance is switched off and disconnected from the
mains when you start cleaning it.
 Remove the comb attachment by pulling it off the appliance (Fig. 9).
 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 10).
Be careful that the cutting unit does not fall to the floor.
 Clean the cutting unit with the brush supplied (Fig. 1).
5 Also clean the inside of the appliance with the brush
supplied (Fig. 1).
6 Place the lug of the cutting unit into the slot and push the unit back
onto the appliance ('click') (Fig. 11).
This appliance does not need any lubrication.
replacement
A worn or damaged cutting unit should only be replaced with an original
Philips cutting unit.
Push the middle part of the cutting unit upwards with your thumb
,
until it opens and then pull it off the appliance (Fig. 10).
Be careful that the cutting unit does not fall to the floor.
Place the lug of the new cutting unit into the slot and push the unit
,
back onto the appliance ('click') (Fig. 11).
Environment
Do not throw the appliance away with the normal household waste
,
at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the
environment (Fig. 1).
The built-in rechargeable battery contains substances that may pollute
the environment. Always remove the battery before discarding the
appliance or handing it in at an official collection point. Dispose of the